Posted by Philip d on September 06, 2021 at 09:49:00 from (96.44.73.155):
My cousin has a beef barn that he was getting power via a light drop cord run across the ground. I had a nice run of 10/3 ACWU (Tec) from a conveyor we no longer use so we made a swap for used roofing steel in exchange for some supplies and labour. He picked up some 10/3 NMWU a double pole 30 breaker and a 4 11/16 th junction box and my work gave me a small panel from a swap out job that needed a little tlc. This morning since were off for the day I put it all together since we ran/burried the cable this sumner earlier. The 3 plugs are now run off of 2 circuits. I used a piece of the 10/3 fed off the double pole 15 breaker in the center to split off and feed 1 1/2 plugs on one side and same on the other as I broke the tab on the center plug on the hot side. We have 2 spare 120V circuits ,were going to use one for lighting later this fall and the one with the broken tab will remain blank. One of the lugs was rusted and seized in the panel but pneumatic tool oil and a bit of work freed it up. It had no bond lug and the neutral as bonded to the frame so I removed the bond strap and added a bond bar to tie in all the bonds. Works nicely and its all labeled.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.