Posted by Aimzter on December 05, 2017 at 21:08:08 from (218.185.84.30):
Hi experts
i really need some help, i just purchased an old david brown 880. It came with a howard slasher and when we viewed the tractor slashing before we bought it it was scalping so i mentioned to the seller that it looks to be cutting a bit low. I figured we could adjust it, so we purchased it.
When it arrived at our place he showed us that he welded on both sides of the slasher some metal plates to help raise the slasher up higher off the ground so it didnt scalp any more when in the down position. I also noticed he had cut the front of the slasher because it was extremely close to the back tyres.
So we gave it a test run it was ploughing on both sides of the slasher and digging in deep to oir grass. It caused a fair bit of damage to the paddock. We tried to raise the slasher but it seems to only have two positions. On the ground or fully up.
I was wondering if anyone can offer some advice as to where to adjust or test to see if we can adjust it. Im new to tracter ownership, im familiar with rideons ad somewhat mechanically minded as we service our own rideon, deck, clutches etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.