Posted by sotxbill on September 16, 2017 at 20:44:33 from (104.5.24.112):
In Reply to: Ford 2000 Overheating posted by fredkotewa on September 15, 2017 at 13:17:49:
okay,, assuming you have a gas model with the thermostat mounted on the front edge of the intake manifold... That model MUST HAVE a tiny bleed hole in the thermostat flange, or the hot water will never get close enough to the thermostat to open. You can either buy a thermostat with the tiny bleed hole or drill one your self. Must in the flange close enough to the center that it will flow a tiny bit of water, even when the thermostat is closed,, this way the water movement will allow hot water to get near the thermostat, and then open it. If the hole is to near the edge, the housing will cover it, and not let the tiny bit of water flow through. This hole will also allow you to bleed all the air out and get the water next to the thermostat. Some models are more sensitive to this, and the gas model 3cy engine is EXTREMELY sensitive to this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.