Posted by Andy R on May 15, 2017 at 22:01:43 from (166.181.82.214):
My Kinze planter has units the same as a John Deere 7000. When walking around the rear I see that one unit is leaning slightly. Seems like everything is at a slight angle. Since everything is at an angle (gauge wheels, closing wheels, double disks, hopper, upper sheet metal) I assume that the shank that comes down between the double disks isn't bent by itself. What is out of whack must be the parallel arms and the heavy metal they bolt to on the planting unit. I think the bushings are OK. Can't remember hitting any rocks. Did make 1/2 a turn with the planter in the ground when the hydraulic valve didn't stay in the raise position. Unit still plants fine - just needs to be straightened up. Anyone ever straightened a planting unit up?????? Thinking of using a heavy wood 4" by 4" or a long 4 inch steel pipe and put some opposite "twist" to the parallel arms back where they attach to the planting unit. Could probably attach a come-a-long on where the closing wheel unit attaches as well to help make a twist. Anyone ever straightened one up????? Maybe it just needs to be disassembled and the parallel arms checked for straightness, new bushings, and reassembled. Thanks for your ideas.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.