Posted by 2510paul on January 04, 2016 at 15:06:52 from (207.118.233.112):
I am trying to decide if the auger to the wagon on my New Idea 329 Sheller is worn out. I have had some issues of drive line breakage to the auger and later finding the auger full of wet corn (say 20 %). This is the basis of my question.
My question is: is there a table or design guideline of some form of how tight an auger should be in the tube it is running for a given angle and grain being conveyed? On my Sheller the auger flights have about 7/16" to 1/2" clearance to the tube wall. That is with the auger biased all the way to one side of the auger tube. I have no way of knowing if this clearance is excessive or not. Are there any other factors I am missing?
Other factors that I am aware of is: 1. the tube has a bow in it from end to end, about 2 - 3", and 2. the tube has a somewhat flattened area from wagon hits when going through ditches. The dents were repaired to some extent but there still is an obvious flat area about 3 - 4" wide and 2 - 3 ft long. The tube is about 6" in diameter.
I am looking for some engineering data that guides the design of augers.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.