Posted by Rich_WI on November 07, 2015 at 09:51:14 from (50.50.86.132):
In Reply to: Fireplace door warped posted by Cooter143 on November 06, 2015 at 14:43:39:
Quoting Removed, click Modern View to see
You cant mount the face/door frame solidly to the fireplace insert (or metal support framework). If you do, the uneven heating and cooling (which means expansion and contraction), things will break and warp. Mortar should never be against anything metal, much less metal that expands and contracts as much as a fireplace. The mortar you mentioning being in there could have caused the warping. More likely though, it was the mounting bolts not allowing the door frame to move through the heat cycles. Mounting bolts should barely be tighter than finger tight and always have washers so the frame can slide under the bolts.
Straighten your door frame.
Make sure you mount bolts allow movement and are not too tight.
Keep anything solid out of the door frame gap (including mortar). Fill will fiberglass rope.
Skip the tapcon idea, thats heading you further down the road you are comming from (failure). Head in the opposite direction (allowing movement).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.