Posted by DMP62 on July 08, 2015 at 09:30:37 from (69.163.26.58):
Thankfully no serious injuries. Was driving to work, came over a little hill and 1/2 mile ahead on the opposite side of the road saw a County tractor & disc mower mowing near a large culvert embankment, my first thought was man he's steep and just that fast over it went. Pulled over, stopped & ran across the road, as I approached it took a few seconds to see any movement in the cab which was unsettling, then I saw the operator was struggling to get to the high side door, I shouted to ask if he was ok & then asked if he needed help with the door. I had to try and climb on the tractor from the high side get some footing to hold open the door as the tractor was more than 90 degrees over due to the steep incline. The operator was then able to climb out and we were able to climb back to the top of the embankment, he had some blood on his forehead and I asked again if he was ok, he seemed more mad at himself than anything, I know the guy a little and he's an older experienced operator who maybe just got caught pushing it a little too far, thankfully this life lesson didn't end as bad as it could have.
Please be safe everyone, so much can change in an instant!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.