Posted by picassomcp on June 11, 2015 at 15:48:10 from (50.107.39.94):
I need to remove this sprocket on my haybine to replace the bearing behind it. This is on the upper conditioner roller on a New Holland 479 haybine. It seems the keyway is wedged in place to hold this sprocket on. There is no setscrew on either side of the sprocket, seems its just the keyway being wedged in there that is holding it on (that I can tell). I for the life of me can't seem to get the keyway out. My access is a bit limited but not real bad. I'd like to get to the keyway from the backside and apply pressure, I've tried that with a prybar, couldn't get much pressure on it, had no luck, even with pounding on the sprocket while prying. Tried a c-clamp, but couldn't get a good bite and that kept slipping off as I couldn't get onto it squarely. I've heated it 2x and tried pounding on it to get movement, still nothing. Any other ideas for me to try??? I'd like to get to cutting some hay here real soon. Thanks for any ideas that you may have.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.