Posted by showcrop on May 03, 2015 at 19:01:14 from (66.31.196.130):
I have my club's snowmobile trail groomer tractor in the shop for some repairs and maintenance. One repair that is needed is to weld back together one ear of the top link mount for the front blade. The pin pulled the bottom two thirds of the hole right off on one side. The mount is part of the frame so it can't be removed. I will V it out to where there is about 1/8th of an inch left. It is about 7/16 thick. The problem is that the two plates are only about 5/4 of an inch apart so if I do it with my Lincoln 225 tombstone I am concerned that I will be at too steep an angle with the surface with my rod, once I get away from the front, to get good penetration. I will be able to get about 2/3 from the top and will go underneath to get the bottom. I was thinking that I could probably keep a better angle on it with my Lincoln 110 MIG. Thoughts or advice?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.