Posted by JD Seller on September 18, 2014 at 20:17:51 from (208.126.198.123):
In Reply to: Re: Barn Lot Posts posted by Fred Werring on September 18, 2014 at 17:30:23:
Fred I weld on brackets after they are set. I also make clamp type hinges that fit the driven steel pipe as well. So you can adjust the hinge up or down as needed.
I just cut a 4-5 inch section of the pipe. I then split it 180 degrees across for each split. I then weld angle iron ears on each piece. The angle iron has a hole in each one for a draw bolt. So you just have a big clamp. I then weld 3-4 inch pieces of pipe on the clamps. I also weld short pieces of pipe on the gates too. So you just have to have drop pins to hold the gates to the posts.
I do have a set dimension that I weld all the pipes on the gates too. So I can take a gate from one place and use it in another place.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.