Posted by fixerupper on July 31, 2013 at 18:50:36 from (100.42.83.15):
The contractor wrapped it up today. There's no gravel on top yet and I expect the county to do that tomorrow along with some finish grading. I'll have a little seeding to do on the CRP filter strip land in that area. I'll give me a chance to put the 10' field cultivator on the back of the 2 banger and make it hunker down a bit. All-in-all they did a good job of finishing it off. I'm not a culvert/bridge expert so I'm not going to judge the rest of the project. It looks good to me. When I drove over it the first time the expanse where the bridge used to be seems so WIDE! For 62 years we've had a little narrow 15' bridge in front of our place. Now it looks like 30' but maybe I'm stretching it a bit ya think? The road will probably be a little rough in that area till it goes through the freeze and thaw next winter but a year from now it should be settled down. Jim
Old bridge
Finished project eight working days later
View through the old bridge looking north. Look at the corn on the left and right sides of the road then look at the corn in the next pic.
Looking south at new grade. The corn is tassled now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.