Posted by Vince Gavin on February 10, 2013 at 23:45:30 from (166.216.162.44):
I recently acquired a GP. 216640. Dont know all about GPs like my other tractors. I dont know if i want to repaint, part out or trade/sell. I am not going into detail on what the guy done but EVERYTHING has been restored, adjusted, replace, bored, sleeved and sealed. Including sheet metal. Just needs lh fender repaired/ replaced and lh radiator casting has a crack need brazed from new core put in. Nothing cobblwd up or welded up. Tractor came from north. Tight steering and put back together for most part. Motor is nice and tight. My thinking is rear rounds arent correct, how do i tell? And the flats on front, even though cutoffs, arent correct? Your thoughts and opinions appreciated. A steam clean and or blasting and shea ready for paint. The guys i run with and get my parts from dont know much about GPs either as I am a collecter of other unstyled tractors and numbere two cylinders. Would like to know where I could get used or repro parts or know if anybody would like to trade for something else I want. Im not going to ask what its worth like other people try to do. She"s still in on my trailer as I have other projects and tractors i would like to get on and this one is tempting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.