Posted by Zachary Hoyt on December 19, 2012 at 06:51:48 from (173.84.189.49):
The alternator I was working on when I had the other question is now installed and working. I put it on the 300 when the alt that was on there stopped working correctly. The one that quit stopped showing a charge on the ammeter, but when I put the cheap digital multimeter I have on the battery posts or on the big terminal on the alt I was getting a reading between 15 and 18 volts that jumped around. I took it off and put in a VR and replaced the rectifier, which had loose insulation around the three little studs. The diode trio looked okay and the brushes were still good. When I put it back on the tractor it was still doing the same thing so I took it off and put on the newly rebuilt one. I would like to get this alt fixed and put it on an Allis C that I am working on. I am wondering if anyone can tell me which parts would cause it to behave like that, or if I should just get a full rebuild kit and replace everything. Any advice will be much appreciated. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.