Posted by wisbaker on September 10, 2012 at 20:56:02 from (207.118.158.205):
In Reply to: compression ratio posted by Brian101MH on September 10, 2012 at 18:46:28:
It's a flathead, valve in block or L head, high compression is not what they're famous for because you have all that additional area over the valves, shave to much off the head and you don't have room for the valves to open or the fuel to flow in and exhaust out. I'm guessing you have a Massey Harris I'm thinking Continental engine. I've seen propane forklifts with six cylinder Continental engines they might have pistons and heads that will help you on the compression if they were built as a propane engines or you might see what the car applications were using for compression (Checker and Kaiser) come to mind. I don't think you'll have compression/RPM issues, heck in the 60's some street cars were running 13.9:1 and they still behaved at lower RPMs, heck my old Pontiac had the high compression and it only ran about 2200 rpms at 70MPH.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.