Posted by 641Dave on June 19, 2012 at 08:09:18 from (64.221.10.32):
Since I can't figure out where the barn is going due to the fact my neighbor can't decide if they want to sell the property I want which will dictate the layout of everything I want to build, I've decided to build a somewhat portable workshop in the mean time to get tools and stuff out of the weather.
I've got a few questions to ask and probably will for a bit here.
First of all, in laying out my first support beams for the workshop, ( I'm putting skids down so if I decide to move it later I can), I was wondering if cinder blocks would be good to use or if I should stack concrete pads until I get my desired height?
I want to make sure our terrier can get under this thing and keep varmits from nesting and burrowing, but I want to make sure cinder blocks will be strong enough to support it.
Shop is going to be 24' x 16' with two lean-tos on either side.
This post was edited by 641Dave at 08:10:10 06/19/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.