Posted by TimWafer on April 25, 2012 at 12:01:18 from (69.193.106.146):
Last fall I wrote about a 656 hydro I had just purchased. I was having a problem with it coasting or at least not being held back descending hills like I think it should. I was told to check the snap ring on the end of the shuttle valve, which I did, but it was intact and looked fine. I then broke my leg and got laid up for quite a while and didn’t get any further with it.
I’ve been using it this spring and still seem to have the same problem. There seems to be no problem climbing hills or pulling. Even used it to plow a little with a 2-bottom plow as my other tractor was laid up. I know a hydro isn’t recommended for tillage but had little choice at the time. The terrain there was quite hilly as well but it seemed to do fine even plowing up hill. No noticeable slipping and the oil stayed at a reasonable temp.
Still when descending a hill it seems to freewheel more than is comfortable. Pulling the lever back or throttling down may slow it somewhat but usually not stop it without the use of brakes. This is the tractor alone now with no load behind and always in low range.
Pulling the lever all the way to neutral usually will not stop it for some distance either depending on the grade of the hill. Moving it to the left toward reverse will however abruptly stop it.
Since it wasn’t the snap ring as I hoped what is my next step?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.