Posted by Zachary Hoyt on February 13, 2012 at 13:10:34 from (74.47.50.90):
I finally got myself together and bolted the winch up to the frame and hooked it to the tractor. I then filled the gear box with 80-90, ran the winch briefly to see that it was working and got out the cable. The top photo shows how long the cable is, before I ran it onto the drum. As I was watching it winding the gear oil began to leak from both sides of the gearbox where the drum shaft comes out. I am wondering if I should take it apart and replace the seals or put in flowable grease that I have heard about on here or look for one of those 'miracle' products that swell rubber and stop leaks. If the correct answer is A, which I suspect, could anyone tell me if there is a place I could find a parts diagram or other information about how to take it apart? I am hoping that I can get seals through NAPA, or our local industrial supply house. The drum has the letters GW inside a circle, which I imagine may be the manufacturers mark. Any advice will be much appreciated. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.