Posted by quartlow on October 10, 2011 at 08:45:03 from (24.101.138.63):
Been looking at pole saws for the skid steer, Decided I could build a better one.
Neighbor donated a hydraulic motor to start with, turned out to be just the right size
Had the 3 inch square tubing.
Robbed the saw parts from an old Echo
Adjuster and drive stuff and the 20 inch bar
The ones you buy are mounted on the edge of the bucket, and that's where I started out. Turns out the bucket blocks your view some of the time. I had the blank makeup plate all ready so I mounted it there, works much better
Bar lubrication comes from the return line, controlled through a needle valve.
Boom folds down around and pins in place for storage/transport. There's also a chain that goes back to the loader arms for transport
I can reach up about 21 feet
The work light does make a difference when working in the shade. Next up is a remote wireless camera
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.