Farmall & IHC Tractors Discussion Board |
560 governor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lee K. on January 19, 2001 at 12:07:59 from (205.160.206.85):
I'm doing on overhaul on my 560 and was checking out the governor before I put it back in. I noticed that the flyweights have been hitting the housing. There's a grove going the whole way around the housing and the flywights have rub marks on the corners. The small thrust bearing on the end of the shaft has a larger diameter hole in the middle than the diameter of the shaft. The bushing below that rides on the flywieght fingers fits nicely on the shaft. I then looked up the governer assambly in our parts book CD-ROM. It shows a stepped sleeve that fits around the shaft and also fits inside the bearing to fill the gap between the bearing and the shaft. I asked my instructor about it, and he said that the parts might not have been available, and some one fabricated something to make it work. I then called the Case IH dealer and asked if the sleeve was still available. The partsman told me that the sleeve was replaced by a bushing, which is on it right now. My question is, why are the flyweights hitting the housing. The flyweight fingers and bushing do not have much wear on them. What can I do to keep the flywieghts from hitting the housing. I want to fix it now before I need a whole new governer. Any help is appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|