Posted by farmall_h_1944 on May 09, 2014 at 21:26:23 from (70.39.24.208):
I am having problems getting my H to throttle up when moving to WOT. The RPMs slow and it dies. I've had it for about 3 years and it ran great until last fall when it just died while driving. Since then I have replaced the manifold, changed the points and condensor, replaced the plugs and wires, rebuilt the carb, and replaced the governor with a used one since the bearings were shot in the other one. I also static timed it to the 1st mark on pulley by loosening the distributor and turning it until I get a spark and then re-tighten it. With all those changes it still does the same thing. It's frustrating and I am not sure what I should be looking at next. It starts fine and I can get it to idle ok by adjusting the carb but when I pull back the throttle it doesn't even want to rev up before it dies. I know the governor is linked up to the carb correctly and I have adjusted the linkage according to the manual. Hopefully someone here has experienced this same problem and can tell me what my next step should be. Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.