Posted by dewy on October 29, 2013 at 16:46:06 from (72.145.215.42):
pulled oil pan to replace had brazing patch on that was leaking,,,smart me pulled pin removed oilpump filter cleaned in kerosene.. poured clean oil all in over it and reinstalled didnt pay attention where notch was that holds it up a little to keep it from fallin all the way down thats the way i put it ,,, it would move up and come down onto notch... also last time i changed oil rubber washer gave me a real hard time oil shot out side ,,,took off redid ,,ozoozed out that time took off again..got back on held that time...this time same thing ,rubber blew out side ,,,whats the trick ,,,,the bolt is funny feelin when you loosen it you have to hold the cover still it it will like thread on ..whats going on and how tight ,,last time i got it to hold ,,i still had to tighten a couple more times over that week ..wow thats the hardest thing i had to do on the tractor and i had the axels out of it........help......dewy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.