Posted by J. Schwiebert on December 10, 2012 at 19:13:45 from (209.143.33.150):
In Reply to: A Waukesha in a W-12? posted by Fritz Maurer on December 10, 2012 at 18:37:07:
Federal-Mogul did not list main bearings any more in their 1991 catalog. Now rod bearings; Here is what I would check. My bearing book for the FC Waukesha shows a rod diameter of 1.749/750, housing bore of 1.8555/18560. Bearing width is 1.060. A Farmall C-113 (like a Farmall A) has the same crankpin diameter, the housing bore is 1.875, width is 1.055 so I would take the shims out and hone the rod bores the extra 020 and use the farmall bearings. The mains you probably need to get the shells repoured. There were so many calls for gasket sets that about 15 years ago Victor started making them again, but a man was looking for a set this fall and I was told Victor has now dropped it again. You might want to post this on the Case form as well since the FC was also used in the RC Case. More questions if you think I can help find me on the Oliver site. Good Luck. J.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.