Posted by TimWafer on April 08, 2012 at 08:34:16 from (74.39.163.74):
In Reply to: 656 front axle posted by TimWafer on April 03, 2012 at 16:23:43:
Success at last! After removing the axle from the tractor I put a 500,000BTU weed burner torch to it and put some firebricks around it to hold the heat in. That did the trick along with some more sledgehammering. I just hope the axle isn’t compromised because of the heat. The drop tubes where the spindles go didn’t get that hot and the paint didn’t even burn off there. The center never got red hot. Most of the heat was concentrated on where the tubes will still be doubled up even when extended so I’m hoping I will be OK. I don’t think it would ever had come apart without heating it up like that so didn’t have much choice anyway. Now just have to clean it up, paint it and reassemble. Tim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.