Posted by c-man on March 09, 2012 at 09:54:59 from (69.77.204.118):
Grinding grain with the 806 Diesel yesterday and all of a sudden it starts to pull down like the grinder was starting to plug. Shut off the corn going into it and it kept pulling down. By the time I could get into the cab, it quit. Just a slow dying process. The filters were good and clean, fuel came out of the bleeder screws on top of the filter cannisters. Fuel came out of the side plate on the injection pump. Not near cold enough to gel up. After checking all of this, got in and it started right up and ran just fine. Finished grinding, probably 15 minutes and it continued to run fine. Any ideas what went wrong? There is a little check ball in the return line(maybe?) that gave us some problems many years ago, but I can't remember what those symptoms were. Could this be the problem? Thanks, I know sombody out there will be able to help!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.