Posted by Zachary Hoyt on January 24, 2012 at 16:49:10 from (173.86.125.27):
In Reply to: H 12 volt conversion posted by Jim Paterson on January 24, 2012 at 16:08:52:
I have a delco 10si on my H and it fits, but it is tight. On the advice of YT folks I put a piece of rubber about 1/4" thick between the alt and the valve cover to keep them from rubbing each other. Picture is from when I was originally asking about it a couple of years ago when my H was new to me. The alt in the picture was what came on my tractor, it was okay having the terminals up but to me they seem to work best pointing down at the long mounting tube, if you get one that is oriented to the side you'll just need to pull the four long screws and turn the back half to the desired position. There just is not room for the wires between the hood and the alternator. I just got through re-wiring my H following the Bob M/Janicholson wiring diagrams that are on this forum, and now my tractor is happy. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.