mike paulson said: (quoted from post at 11:27:20 06/25/11) just wanna clarify i'm not talking about lead length but extension cord lenght,..
i do have the correct line cord rated for the welders electrical draw, just wanna know what some of you guy's have.
and am i going about this the right way, should i be extending my leads instead of my extension cord? and if i do make a second extension cord is it ok to have a 30 and a 40ft plugged into each other or must it be a strait run? thanks for any info. i'm looking for about 70ft.
I think John T is telling you right.
I think it would be cheaper to extend the power cord than the welder leads. every foot of wire has a little resistance... the bigger the wire the less resistance. the longer the wire the more resistance. the more current across a resistance the more power is wasted as heat... the heat is not good for the insulation on the wires and any power wasted in the wires is not used for welding... what you're paying for it for.
I think number 6 is what you want for 70 feet at 2% voltage drop you could probably get away with number 8 if you really wanted to.
This post was edited by realolman at 12:31:05 06/25/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.