Posted by pete 23 on April 01, 2011 at 10:37:53 from (74.44.100.190):
In Reply to: tel-a-depth question posted by Matt (NEIA) on March 31, 2011 at 16:00:22:
The teledepth is for positioning the hitch only and the draft control portion of the hitch is controlled with the large handle lever on left side. Higher you pull lever up, more sensitive hitch is. You must have the lower float lockout pin removed to utilize draft control. My suggestion "forget about it" unless you are plowing contoured up and down land. Then it may keep a more even depth control of the plow than you can manually. Have to remember, all draft controls attempt to maintain a steady draft on tractor so if front of tractor goes down, mounted plow goes up, with draft control it will automatically sink that plow in to keep even pull and vis versa when front goes up. On varying easy and hard pulling land it will vary the depth of the plow to maintain the even draft. In our level land around here it was just basically locked out, but I have seen it work well on hilly land with the newer draft controls systems but not on that old mechanical type you have on that tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.