Posted by Dr. Bert on November 19, 2010 at 17:29:38 from (72.36.56.171):
My loader tractor is an M with 7.50 X 16 front tires, an F11 loader with a 8 foot bucket. At present no power steering. Equipped with a Schwartz front end. With a load in the bucket this unit was almost impossible to steer, so I lengthened the front spindle steering arm 4 1/2 inches-no change to the bellcrank at the bolster- drilled and tapered holes for the ball joint studs, adjusted the tie rods to align the wheels and took it out to try. I chained a 9N tractor minus the block and rear tires to the front of the bucket and lifted same. Going to my shop I could easily steer,no more standing up and straining. I was advised that this would drastically change the turning radius, but because of the way the tie rods are attached to the bellcrank at the bolster, I noticed very little difference. Thought I would try this experiment before mounting my PS unit just to satisfy my curiosity. Sorry this is so long, but thought it might help others.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.