My TC-55 Farmall 400-450 parts book has one picture with the tach hole on right side. It lists two descriptions. The first is for Farmall 400 tractors 501 to 23615. The tach hole cover and screws are included.
The second is for F-400 from 23516 to "up" and F-450 from 501 to "up". No mention of tach hole cover. Must be an oversite.
Can't say that I have ever seen a left side tach hole. Maybe I can find a picture in one of my books. It seems from what you say, my F-400 tach should have been installed on the left. But I think a recess was there on the right similar to the embossed "hole" in a Cub dash panel.
It's been many years since I installed the tach on the F-400. For some reason, I thought I had to knock out the sheetmetal "plug" or use a hole saw rather than remove a screwed on cover. I'll have to take a closer look tomorrow to see if the nuts are embedded or whether they are separate.
Just for the halibut, below is a F-450 shroud
This post was edited by Wardner at 21:25:34 05/16/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.