Posted by Scot in pa on March 29, 2010 at 18:36:41 from (68.28.104.225):
In Reply to: 656 Rear Axle Removal posted by Formerly PaMike on March 28, 2010 at 08:27:46:
I'd imagine the hub will come off the end of the axle without any further disassembly. I do believe that if you have to pull the axle that the housing has to come off. One tapered roller bearing rides out near the outer end of the housing, and another is on the inboard end of the axle and rides in a race in the main rear-end casting. The axle comes out of the housing toward the transmission.
Someone correct me, but I am thinking the 6's had inboard bull gears. The bull gear needs to be unbolted from the end of the axle and supported to pull the housing, too, if they did. The 7's and up had outboard bull gears and the bull gear is inside the axle housing.
If you have to replace the axle you may as well spring the extra money and get a new seal and bearings, too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.