Posted by BruceS. on January 23, 2010 at 14:26:40 from (76.15.41.143):
Got a new seat pivot shaft and bushings for an EZ Rider seat on my F30. The bushings had long since disappeared. How on earth does one put this thing back together? The bushings (tapered end goes toward tube, right?) will not even begin to start to go inside tube where seat pivots. I tried dish soap, silicone grease, but no luck. How are the bushings supposed to fit? Are they supposed to fit part way into the tube, or somehow squeezed together to fit into the outside bracket where the bolts on each end. The bushings are simply too big for the pivot hole. Someone must have an answer. BTW, as far as I can tell, the pivot shaft and bushings must be assembled at the same time. Bushings cannot be put in first. Any ideas welcomed, and sorry for long post. I guess I'm venting a bit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.