Lance_MF_180 said: (quoted from post at 06:18:24 01/14/10) Thanks Everyone! I will looking for the input gear from a Super M then if I am understanding correctly!?! This M goes on the blower during silo filling, light plowing with a 3-16 melroe pull type auto reset, and sometimes disking with a 13 foot disk after chopping just to level rows out. Major tillage is done with an IH 886 and a 6-16 melroe onland plow, but I love the sound of the M pulling hard anyday before that diesel 886!
I am fairly certain you are looking for the 4th/5th gear. The input and ring gear would make you go faster in all gears. If you wanted to go slightly faster in all gears you could put an I or W 6 ring gear and input in. If you find one have fun paying for it!!!
You can't pull a 13 foor disc with an M!?! You are so full of... Don't worry, it is coming. I have seen it all too many times. The people like to say you have to pull a 9 footer on this board. :shock:
I don't see my picture above, I will try again on this post.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.