Posted by Marlin2 on January 13, 2010 at 16:00:43 from (70.198.225.18):
In Reply to: 1486 PTO removal posted by Ron in Mississippi on January 13, 2010 at 10:36:08:
18:35:55 75.195.57.88 746418
Report to Moderator
Re: 540 PTO shaft Needed for 1486 IH in reply to Ron in Mississippi, 01-11-2010 12:02:13 My advise is to take it off the back of the tractor and take it to your local dealer or a good local tractor mechanic.That clutch return spring is wicked,if something bad happen it could hurt you very bad.Taking off the pto unit is easy.Put a clean pan under pto take out all the long bolts around it.The two short bolts leave in,but there is a short bolt in the lower left (bolt is hard to see) corner remove it the pto should come off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.