Posted by Mark Peters on September 14, 2009 at 15:26:58 from (66.222.7.225):
In Reply to: Fast Hitch Farmall C posted by glennster on September 14, 2009 at 08:17:13:
Carl Beck said: (quoted from post at 11:17:13 09/14/09) Is there a way to adjust the two receivers on a fast hitch to gain a fraction of an inch additional distance between them. I have an impliment that is 1/4 of an inch to wide and I haven't found a way to create even that much play between the receivers.
Carl, There is no adjustment on spacing to the sockets on the fast hitch. Both large and small prong fast hitches use the same 28" spacing.Small point FH implements will fit into large socket FH with the use of 1/2" thick filler plates. The only difference between the large and small FH is the 1/2" height difference of the points(3"' high on large vs. 2 1/2" high on small).
My guess is either the bail( the part of your fast hitch with the sockets on it) or the prongs on your implement are bent or sprung.Measure both hitch and implement to see if they are 28" center to center.If either one is sprung or bent, the use of a hydraulic porta power or other method of straightening is called for.Hope this helps,Mark
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.