Posted by mkirsch on December 02, 2008 at 05:58:35 from (64.80.108.56):
In Reply to: 460 tire size posted by scott mcintosh on November 30, 2008 at 17:24:11:
First number is width. Second number is rim size.
There is no law against going wider or narrower, within reason. Maybe a half inch to an inch in each direction of the OEM size.
You can't use a tire meant for a different rim diameter. The only time this isn't obvious is if you're putting 16.5" tires on a 16" rim. They'll fit but the beads don't make proper contact with the rims and could slip off under heavy loads, or even during mounting. I'm sure there were many injuries and probably a few deaths associated with the 16.5" tire size. That's why they are not common any more.
There is no problem using 6.00x16 in place of a 6.50x16. You probably can get the tires cheaper, right? They'll be narrower and a little smaller overall.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.