Gas to diesel, it's worth it if the cost of the engine, parts, and labor is less than the cost of rebuilding the gas engine, and there's nothing wrong with the diesel engine.
You will recoup a bunch of money though fuel savings too, but how much depends on how much you use the tractor. For Dad's 756, the gas bill went down by 1200 gallons, and the diesel bill only went up by 300 in the first year after we had a D360 installed. Basically, the conversion paid for itself within 2 years.
There are a LOT of small issues to deal with in the conversion.
First off, the diesel's rear engine plate is about 3 times thicker than the gas engine rear plate. To compensate, the frame rails on a diesel are shorter. To make it an easy bolt-up, you need to get diesel frame rails. We kept the gas frame rails on the 756, and it ended up about 1-1/2" longer, so the hood doesn't fit anymore, the power steering lines were too short, and countless other things were thrown off. We lucked out and found a mechanic who wanted to do it just for the challenge, and he had a blast figuring out how to meet all the challenges. Some of his solutions were a little cob-jobby, but Dad fixed them all eventually, and made extensions for the hood.
One biggie was that the bottom coolant outlets on the engine and radiator were on opposite sides. The mechanic had his son weld up a custom radiator pipe to cross over, rather than purchase the correct radiator at $500+.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.