Posted by Crabby Red Power in SE-WI on September 12, 2008 at 13:03:46 from (68.114.236.202):
I figured I'd post this in the Red Room, too. I thought I'd give everybody a heads up on the knife guards (MC2041z - single) Case IH is selling nowadays to for the International 100 - 1300 balanced head mowers. They're forged & don't bend, no matter what you do. You can pound on them 'till the ledger plates rattle loose & you can bend them until they snap... My only advise would be to shim them up .010" - .030" behind the bolt. This should bring the plate up, sufficent enough, to contact the front of the knife & give you your .014" - .031" clearance under the knife at the back of the leder plate. Or, if time permits, find some n.o.s. guards. They should still be malleable steel & not hardened. I spent the last two weeks rebuilding (beating up) a cutter-bar & thought y'all might like to know my findings. If you already knew this, my apologies. - Mike
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.