Posted by Dan Swanson on May 18, 2008 at 20:45:47 from (63.172.252.161):
Have a set of 8 -1 pece and two piece weights that came off an 806 with 34" and I want to put them on my 856 with 38". After measuring the mounting holes in the wheels on both tractors they are the same dementions. The hole in the wheels are 16 1/2 OC cross ways and 12" OC hole to hole. The 1 piece weight holes are 15" OC cross ways and 10 1/2 " OC hole to hole. I know this is a simple matter but I can't figure out how to get the first weight installed so the rest will bolt up. I didn't go thru the whole stack of 1 piece weights but is there a starter weight I need to use that lines up with holes on the wheel or do I start with a couple of two piece weights? I have looked in my owners manual and the IT manual but there is no mention how to mount them other than bolts sizes needed. Attached are a few photos of the two tractor wheels and of the weights. I did notice some of the one piece weightsare 8887-D 1 and some are 2's and a couple are marked with just a W-9. Any help would be great. Or a photo would work too. Thanks Dan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.