Posted by Bob Kerr on May 18, 2008 at 07:34:20 from (205.188.116.73):
In Reply to: OT, Ethanol at home posted by IndianaRed on May 18, 2008 at 06:41:31:
You can build your own like a moonshine still. you do have to register with the state but I heard that is easy to do as you have to promise the alcohol is for fuel and will be made non drinkable. As far as sugar goes, not nessesary if you "malt" the corn. The corn already has the enzimes needed inside the kernal to make sugar from the starch. That is what the plant grows on when sprouted.you then have to dry and grind the malted corn. A high alcohol tolerant yeast is a good idea because the wild yeast may "drown" in its own alcohol. 2 runs through the still are nessesary to get high proof stuff and then you can hang a bag of a dessicant material inside the finnished barrel to remove water. It is almost impossible to remove all water but you can get it to a useable point. The dessicant can be reused if you heat it afterwards. As far as fuel goes, scrapwood or limbs are the best bet as far as cost goes. It would also be a good idea to have your own hogs to feed the old mash to. You can have the hogs butchered when fat or sell them off and make more $$ to offest the cost. If it sounds like a lot of work, it is! I think it would be a better idea to make ethanol out of Sorghum stalks! and feed the sorghum grain and stalk mash to hogs or cattle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.