Posted by landlord7012 on April 11, 2008 at 15:42:36 from (206.40.110.229):
I'm tearing down my H motor which was stuck from sitting 25 years under a leaky roof. With the head off, cylinders 1, 2, and 3 don't look too bad and I should be able to free them with little or no force. Number 4 is "petrified" from being full of some muddy-pulpy gunk and will require brute force to free. I plan on replacing the liners, pistons etc. anyway so my question is this: do I need to free that piston up or should I leave it in and pull the motor and just unbolt the rod from the crank and pull the piston and sleeve together? My thinking is to save the abuse to the rod and crank if possible (and a little time and energy :) ).
I must add that I am glad I listened to those who say "take the head off" 'cause I couldn't imagine the damage I would have done if I could have freed it with all the cocktails I used. The inside of the manifold looked like a cave full of stalagtites and stalgmites. I'm not criticizing those who have freed motors without disassembling them as I'm sure there are varying degrees of "stuck" but just acknowledging the fact that sometimes haste makes waste. Pulling the head put a whole new light on things!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.