Posted by Eds on February 13, 2008 at 12:56:35 from (70.130.245.107):
have a farmall 300 that needs some work. I just have not quite figured it out yet and it has not been a priority for me. I saw it setting outside and after looking for the owner for a couple years I found him and purchased the tractor. I got it running good but the starter drags on it. I have checked the starter out and even had it checked out and it still drags it will drag and draw high amps and get the wire hot when trying to start it. I put a pry bar on the fly wheel and the flywheel seems to not turn free enough. It runs very strong and everything operates as it should when it's running with no odd noises all the fluids look to be good. When the weather warms up a bit I will look at it a little closer I pulled the plugs on the engine and it still turns hard. From looking at the book I noticed a pto disconnect lever under the tractor that if I remember correctly engages a shaft that turns off the flywheel. I am going to disengage that lever which should disengage the pto. I am not sure but was thinking if the pto is not adjusted properly maybe it's causeing the drag. Any suggestions thanks Ed
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.