Posted by Mike CA on January 16, 2008 at 21:23:11 from (75.31.169.20):
I have to get a new front end on my H. Right now it's up on jack stands.
I have a guy in my tractor club who has an old narrow front ped with two hubs, but only one rim. The side with the rim is seized, and the whole think is a bit rusty and rough. $20 for it. So, I'll need bearings, a rim, tires and tubes.
There is a complete ped at the junkyard for $100. I don't remember the condition of the tires. But it's also yellow, and I don't know when I could get some paint on it. It's a 45 minute drive, so I want to go for something other than just looking.
Anyway, I figure for the broke ped I'll be spending $30 for a rim. Tires, $20 a piece if I can find some. (Allan in NE mentioned he'd give me his off him new M, but shipping could be just as expensive) and I have no idea what bearings will cost me. But it all potentially could come out to less than $100. And every dime counts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.