Good question, complex answer. The diagrams (Bob M's) will be fine for making stock lights with equivalent wattage 12v bulbs work correctly. If trailer lights are needed, or additional tractor lights, they should be supplied separately from the load side of the Amp gauge with a separate 20 amp fuse and switch. The original light switch will not carry the load. Lights should be placed on the wagon such that all corners are lit. at the height of the flat of the deck. Reflective tape should be placed on the rear to mark the top right and left corners of the rear endgate. Running 14 gauge Zip cord (two conductor vinyl covered appliance wire) down each side works well and is tidy. If you use LED lights, the cord can be 18 gauge, and the light switch would handle that added load. It will not handle bright halogen headlights or tail illumination lights. I would use a switch box and fuse that can be disconnected easily and kept with the trailer lights to make it easy to get ready the next time. Good fun, JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.