Posted by ChadS on October 09, 2007 at 06:00:46 from (4.224.78.18):
In Reply to: Tractor swap posted by NICK KOEPPE on October 08, 2007 at 19:25:10:
NICK KOEPPE said: (quoted from post at 19:25:10 10/08/07) I would like to know if I can take a motor out of a 1256 international and bolt it to a 560 international and if so. What would be some thing that i may want to look at and any help would be nice
Been told a 361 out of a 806D will bolt right in using the 806 front frame on the 560 bellhousing. Possibly, the starters work,,, supposed to be close to, or the same specs as a 560,,, but the tooth count on the ring gear might be wrong, could be as simple as changing a starter, or??? Might have to look at the input slpins on the clutch disk, but, been told that it should bolt together. ChadS ChadS3@hotmail.com or www.thetractorshop.com
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.