Posted by JMOR on August 17, 2007 at 17:59:26 from (76.185.68.29):
8 foot Austin MFG. It has never cut worth anything since I got it (used). Sharpened several times, compared the RPM, gear box ratio to another that I have (single 5 ft) and when blade diameter is taken into account, both are 10,000 feet per minute tip speed (about same as found in eqmt catalogs). One cuts good, one poorly. The poor 8 foot has two rotating systems and now that I have checked and compared most things, I'm wondering that if it's earlier life, someone had it apart, swapped the gear boxes or something that would maybe cause the blades to rotate in opposite directions (yes the sharp edge hits the weeds first),but that is just flipping the blades over.)
As it stands now, the left rotates ccw & the right cw such that in the middle, it slings cuttings forward and on the outsides, it slings toward the rear. Anyone out there have a two head cutter and know directions of rotation or any other idea why this one cuts so much worse than the other? Should blade plane be level? The good one has a slight downward rake at the front, about 1 inch lower than the rear.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.