Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 carburetor adjustment
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on August 06, 2007 at 18:02:55 from (204.249.178.32):
In Reply to: Farmall 300 carburetor adjustment posted by Chief Pete on August 06, 2007 at 13:03:51:
Sounds to me like your float setting is too high. Five turns out or not it should not smoke. The jet on the 300 carb is really a fixed jet, but you can reduce the fuel consumption by turning the needle in. When I bought my Super H, I did not know that, as I hadn't read the manual. I rebuilt the carb and adjusted it as you do an H or M carb -- in until rough and out until smooth, plus maybe a fraction of a turn more. Any load or any incline, etc, the tractor cut out. That is when I read the manual. You set the screw 5 turns out initally, and then turn it in for light loads. As a kid I drove an H fully loaded, and I do mean loaded -- I would have loved to have had that Super H carb.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|