Farmall & IHC Tractors Discussion Board |
Re: Super C won't start?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ScottyHOMEy on July 15, 2007 at 07:21:29 from (70.105.246.111):
In Reply to: Re: Super C won't start? posted by Dan( Mass) on July 15, 2007 at 04:06:17:
My #1 is actually closer to 10 o'clock, meaning closer to the engine, but that doesn't mean yours is. Best thing is to start from scratch. While you're turning the engine with the cap off, check to make sure the points are opening and closing properly. When you get the engine to the top of the firing stroke on #1, put your rotor button back on. Where it lines up is where your #1 wire will go. In case it's somehow got turned way out of time, you might try putting the cap on temporarily and mark the distributor body where the tower for #1 lines up, then remove the cap and make sure the rotor is pointing fairly close to that mark. If not loosen it up and turn the body until the mark lines up better with the rotor, then tighten ity back down beofre putting the rest of the wires on your cap and closing her up. 1-3-4-2, clockwise
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|