Farmall & IHC Tractors Discussion Board |
Cub Magneto timing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DCW on July 08, 2007 at 05:59:13 from (156.34.196.50):
I have a 48 Cub,with a magneto.This is my forth Farmall,but the first with a mag,so I'm unfimiliar with it.I pulled the rotor button off and the plate,then filed and gapped the points,but I can't get it timed.I'm to understand that the pinion that drives the rotor has a timing mark on it,and so does the rotor.Does this mean that when No 1 is at TDC,THAT THIS MARK ON THE ROTOR DRIVE SHOULD BE AT THE 12 o'clock position? If I try timing it,all it will do is blow flame out the exhaust(way too late).Or not fire at all.This little tractor needs a resto,but it would run,albeit poorly due to stuck valves. Any little bit of info would be helpful.Thanks.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|