Farmall & IHC Tractors Discussion Board |
Super MTA Hydraulics Operation
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Smith1000 on June 24, 2007 at 08:53:58 from (70.41.100.224):
I can't quite figure out how to operate the remote two-way hydraulics on my MTA. Book says to pull "Lift All control rod" (top rod for raising 3pt) all of the way back and lock it into place. Then unlatch the "Remote control valve lever". It says to then move the "Remote control rod" forward or back for up or down pressure. I understand this, but, when I do this (pull the remote rod back to open the gate), it will raise the 3pt first. When the 3pt bumps the drive shaft and stops, it will then proceed to raise the lift gate on the baler-like it is supposed to. If I then push down, it will push the gate down (shut it)---but the 3pt is stuck up against the drive shaft until I lower the All lift rod. How does one lock the 3pt in place so that the remote hydraulics only operate the rear gate? I could let the 3 pt raise and lower to the max I guess, if I put the draw bar back on to attach the baler to (it would not collide with the drive shaft). Right now though, the 3 pt wants to collide with the drive shaft first--which isn't going to work. Thanks.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|