Farmall & IHC Tractors Discussion Board |
Re: Need gasket for oil filter base for a F-12 or
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by moseed on December 26, 2006 at 15:59:56 from (207.177.239.36):
In Reply to: Need gasket for oil filter base for a F-12 or F-14 posted by tractor hank on December 26, 2006 at 15:06:12:
Hank, Hal's right and the filter one is the thin paper, not cork. It has three long slots that are close together as well as the perimeter and bolt holes so if you have never made one before you might want to pick an easier one to start with. If your not into making them call Skip or Bob at (The Fordson House 1-906-786-5120)or Gorden Rice at(1 (814) 226-9200)for F-12 and 14 gasket sets. They sell many gaskets separatly also. Talk to both because often one will have different deals than the other and each also has different areas of expertise which is a whole bunch on each side. Two good sources for parts and gaskets. Good luck.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|